Instruction manual GLM-I About the device
38.019.129.001 en 33
2
2.9 Warranty
We disclaim any liability for damages caused by:
– Non-observance of operating conditions
– Non-adherence to this Technical documentation
– Unauthorized installation
– Defective electrical installation by the customer
– Structural modifications to our equipment
– Removal of lead sealings or calibration seals
– Incorrect programming and operation
– Backup not executed
– Natural wear and tear
The warranty will lapse if defects/damage occur as a result of utilization by persons we
have not authorized. In addition, there will not be responsible for any liability if any other
spare parts than Bizerba parts are used, especially thermal labels and ticket rolls, which
are not manufactured according to Bizerba specifications and not approved by Bizerba. If
you have any questions on warranty, spare parts or resources please contact your Bizerba
consultant.
If you reset or program devices, check the new setting with a test run
and test printout. This helps to avoid faulty results
.
Check that our products are handled correctly and repeat training if nec-
essary.
2.10 Disposal/Environmental protection
The legal disposal/environmental protection terms of the respective countries apply.
Only valid for Germany!
Batteries are fitted in this device which are subject to the Battery Ordinance on the return
and disposal of used batteries and accumulators
.
This ordinance requires you, as the end user, to return the device to the manufacturer or
dealer, at the end of its proper use, for the purposes of recycling and correct disposal.
If your device contains a rechargeable battery, you are required by the Battery Ordinance
to return the used battery to the dealer or to a public return point provided for this purpose.
To Next Page
Loading...
Need help?
General
