Instruction manual GLM-I About the device
38.019.129.001 en 27
2
2 About the device
The device consists of the following components:
Conveying unit
–
Conveying unit with infeed and separation belt
– Weighing conveyor
– Light barrier for package identification
– Two-part or one-part conveyor belts
– Optionally active package guidance for different packages
– Quick clamp device for simple removing of belts for cleaning purposes
– Conveying direction depending on design of device
Weighing system
– Integrated load receptor under the weighing belt
Labeling station
The labeling station is a separate unit with conveying frame, labeling belt and labeler. Sev-
eral labeling stations can be set up in a row for multi-labeling. The following labeling sys-
tems are available:
– Air-jet labeler for labeling from top or bottom
– Rotary arm labeler for labeling from top, side or front
– Piston labeler for labeling from top or bottom
– Belt labeler for labeling from bottom
Label printer in labeling system
– Thermal direct or thermal transfer label printer
– Take-up unit for the label roll and for the take-up device for the conveyor belt
– Take-up unit for thermal transfer belt roll and for the take-up device
Switch cabinet for belt control and interfaces
Depending on device version the power electronics, the I/O interface as well as the mains
switch are located either under the infeed or separation belt or in a stand-alone switch cab-
inet. It contains:
– Main switch (outside of switch cabinet)
– Control and performance electronics for up to 9 belt drives
– I/O interface for up to 40 programmable inputs and outputs
– Standard interfaces RS 485, RS 232, optional: RS 422, Ethernet
To Next Page
Loading...
Need help?
General
