Texts Instruction manual GLM-I
184 38.019.129.001 en
15
15.4.2 Managing the date text in the database
You can manage date texts in the database and assign them to PLUs via the date text
number. When a PLU is changed, the assigned date text is accessed automatically.
If you change a date text in the database, the change is applied to all
those PLUs to which the date text is allocated
.
You can also start this function from mode level 2. Initially, the proce-
dure is the same as entering a date text for the current labeling job
, see
page 185. If you press <Save> after editing, you are prompted to enter
a password. After entering and confirming the password for mode lev-
el 3 (save locally) or 4 (save globally), the continued procedure follows
the description from Entering the Parameter Number, mentioned below.
Mode level: 3 (local) or 4 (global)
<Date text> / <Date text editor>
<Load>
Enter and confirm date text number, see page 77.
Edit text in the text editor, see page 167.
<Save>
Enter and confirm the date text number you want, see page 77.
If a date text already exists for the entered number, a security check prompt appears.
If you answer <yes> the text is saved in the database under the entered number
.
Close text editor via <Exit>.
To Next Page
Loading...
Need help?
General
