Interfaces Instruction manual GLM-I
406 38.019.129.001 en
30
30.6 Outgoing connections
30.6.1 Send data
The device can send data and commands via the AEDP channel, the system bus or TCP/
IP to other devices. Use the following table to determine which data are sent via which
channel to which device
:
<Connecting parame-
ters>:
Determines via which logical interface a connection already ex-
ists for the data you want to send, and which physical interface
is behind each respective logical interface. Logical interfaces
are called channels, see page 409.
<PSV_PCK WDout flag>: Determines which package or total data are sent via which
channels, see page 411.
<Add.data to
PSV_PCK>:
Determines which additional data are sent with the package da-
ta via which channels, see page 411.
<Contents of PSV_DA-
TA>:
Determines which package data are sent to the higher-ranking
EDP system, see page 412.
<Send if data is mod.>: Determines which data and commands are sent to which chan-
nels by the operator on the event of a change in value, see
page 412.
<Add. data to statistics>: Determines which additional data are sent during weight-class-
specific labeling plus active statistics in a statistical evaluation,
see page 325.
To Next Page
Loading...
