Operation Instruction manual GLM-I
338 38.019.129.001 en
24
The configuration of the tare input is not subject of this documentation.
For further information please contact your Bizerba consultant or Bizer-
ba Service.
Mode level: 1
Sequential control
<Manual> is set, see page 272.
Place packaging on the scale.
<Tare>
The weight display is set to zero. Before the weight information appears text "NET" is dis-
played.
The tare value remains saved until next article change or until next tare weighing
.
24.8 Labeling
Prerequisites:
–
The device is configured for the production environment.
– The article to be labeled is called up, see page 141, or the required article data were
recorded manually as described in the following:
– in the current article data table
– via single functions
– The article data are complete.
– The scale has been zeroset.
Start device
Press <Start>.
The conveyor belts start.
Infeed packages
With manual package infeed: Infeed packages taking into consideration the conditions
for package infeed
, see page 335.
If no packages are fed to the device for a defined period of time, the conveyor belts
stop automatically. As soon as packages are fed again
, the conveyor belts start auto-
matically.
Stop device
Press <Stopp>.
24.9 Cancel
If packages are defective, you can cancel these packages from the totals. The following
options are available for this purpose
:
– cancel via numerator, see page 339
– cancel with minus tool, see page 340
To Next Page
Loading...
Need help?
General
