Totals Instruction manual GLM-I
288 38.019.129.001 en
22
22.2.2 Entering preselection value for total 1 to 3
After defining the size that should trigger a total, you have to enter a value for the prese-
lection. For a piece-preselection, enter the piece number to trigger the total, for a price pre-
selection, enter the price total etc. The softkeys offered vary according to the preselection
type that is set, see page 287.
Example: Total memory 3. The procedure for total memories 1 and 2 is the same.
The following softkeys are supported for total memory 3 depending on the preselection
type:
<*3:Preselect pieces>:
Enter preselection value via <Presel. piece *3>.
<*3:Preselect weight>: Enter preselection value via <Weight preselect.*3>.
<*3:Preselect price>:
Enter preselection value via <Price preselect.*3>.
<*3:Secondary price>: Enter preselection value via <Secondary price *3>.
<*3:Number of total 1>: Enter preselection value via <Number *1 in *3>.
<*3:Number of total 2>: Enter preselection value via <Number *2 in *3>.
<*3:Pres.via si.numer-
at.>:
The preselection value is not set via a softkey. The end value of
the individual numerator is used as the preselection value.
Mode level: 2
<Configure total> / <Presel. total> / <Presel. piece *3>
or
<Processing> / <Presel. total> / <Presel. piece *3>
Enter value and confirm input.
If you change the preselection type, the preselection value entered for
the previous preselection type is reset to
"0".
22.3 Configure equaled total
If you preset sub- and overall totals during labeling, this is where you can configure the
sum, which, when reached is considered the overall total
.
Example:
Box total = 88.18 lb
(Total 1)
Pallet total = 1,102.31 lb
(Total 2)
After 12 box totals at 40 kg each, you have a pallet total of 480 kg.
After 13 box totals at 40 kg each, you would have attained a pallet total of 520 kg already.
To Next Page
Loading...
Need help?
General
