Instruction manual GLM-I Label data
38.019.129.001 en 209
18
18.11.3 Activate or deactivate supplementary text
In standard labels you can use this function to print an additional text in Text 3 on the bot-
tom edge of blank labels, see page 176. The following settings are possible:
"W/o": Text is not printed. Standard setting.
"With": Text is printed.
In order to create space on blank labels for an additional text, set the
next-smallest label size
.
Mode level: 1 or 2
Mode level 1: <Etc> / <Labels> / <Layout options> / <Etc> / <Texts> /
<Additional text field
>
or
Mode level 2: <Labels> / <Layout options> / <Etc> / <Texts> / <Additional text field>
Touch softkey until required setting is achieved.
18.11.4 Activate or deactivate total text
Decide here if you want to print the texts "Batch total 1" to "Batch tot3" on total labels in-
stead of the PLU text in total 1 to total 3. The following settings are possible
:
"W/o": The PLU text of the last labeled PLU is printed in addition to the
totals. Standard setting.
"With": The texts "Batch total 1" to "Batch tot3" are printed in addition to
the totals.
Mode level: 1 or 2
Mode level 1: <Etc> / <Labels> / <Layout options> / <Etc> / <Texts> / <Total text>
or
Mode level 2: <Labels> / <Layout options> / <Etc> / <Texts> / <Total text>
Touch softkey until required setting is achieved.
18.12 Switch digit code on or off
A special digit code can be printed on labels in the device number field. The three-digit
code is put together from the two-digit department number and a weighted check digit. The
check digit is formed from the maximum 6-digit selling price and the maximum 2-digit de-
partment number. If one of these specifications is exceeded, no digit code is printed.
The digit code can only be printed if no lot number and no operator number was entered.
The department number is entered as the device number, see page 278.
To Next Page
Loading...
Need help?
General
