To Next Page

To Previous Page

Instruction manual GLM-I Accessories

38.019.129.001 en 455

To open an existing tendency control parameter table for editing, enter and confirm

the tendency control parameter number of the desired table

, see page 77.

31.14.4 Editing the tendency control parameter table

Tendency control parameter tables are edited the same way as generally described for ta-

bles.

Editing table, see page

Saving and closing table, see page 85

Printing table data, see page 83

31.14.5 Deleting tendency control parameter tables

This function is used to delete a tendency control parameter table, see page 86.

Mode level: 3 (local) or 4 (global)

Enter and confirm a tendency control parameter number, see page 77.

To irrevocably delete the tendency control parameter table, answer security query

with <yes>.

31.14.6 Calling up tendency control parameter tables

Tendency control parameter tables are usually allocated to PLUs and automatically called

up whenever a PLU is changed

. They can also be called up independently from the PLU

for the current labeling job.

Mode level: 1

Enter and confirm the tendency control parameter number for the desired table, see

page 77.

The selected tendency control parameter table is called up. All the settings here included

are applied to the current labeling job

31.14.7 Modifying current tendency control parameters

This function is used to modify the currently applicable tendency control parameters in a

table. The changes only apply to the current labeling job and are not applied to the data-

base.

Mode level: 1

Make changes.

Save table and exit, see page 85.

Bizerba GLM-I User Manual

Questions and Answers: