Weights and ingredients Instruction manual GLM-I
146 38.019.129.001 en
13
13.5.1 Configure printing of weight dimension on single labels
Determine here how the weight is printed on single labels.
You can also enter this setting, providing the database has been config-
ured respectively
, in label parameter tables.
The following settings are possible:
<Without weight dimen-
sion>:
Print weight without weight dimension
.
<With weight dimen-
sion>:
Print weight with weight dimension. Standard setting.
<Weight dimens. with
space>:
Print an empty space after the weight followed by the weight di-
mension.
Mode level: 2
<Article data> / <Weight> / <Print weight> / <Unit of weight>
Press softkey with respective setting.
13.5.2 Configure printing of weight dimension on total labels
Determine here how the weight is printed on total labels. The following settings are possi-
ble:
<Without>:
Print total weight without weight dimension.
<With (normal)>: Print total weight with weight dimension. Default setting.
<With (rotated)>: Print total weight with weight dimension rotated by 90°.
Mode level: 2
<Article data> / <Weight> / <Print weight> / <Unit of weight> / <Unit of wgt for totals>
Press softkey with respective setting.
13.5.3 Activate or deactivate tare printing
Determine here whether single tare or total tare is printed on the labels. The following set-
tings are possible
:
– "no". Default setting.
– "With"
Mode level: 5
The tare value can only be printed on 68 mm standard labels or respectively configured
customer labels.
<Etc> / <Scale menu> / <Tare> / <Tare printing>
Touch softkey until required setting is achieved.
To Next Page
Loading...
Need help?
General
