Automatic machine parameters Instruction manual GLM-I
264 38.019.129.001 en
20
20.8.8 Entering speed of pressure roller
Enter the pressure roller speed as factor in percent depending on the belt speed.
The device is equipped with a pressure roller.
Mode level: 1
<Device menu> / <Transport equipment> / <Speed IF/ press. roller>
Enter and confirm speed.
20.8.9 Selecting operating mode for weighing belt
Here you may change the operating mode for the current labeling called up via automatic
labeler data
. The following settings are possible:
<Transport>: No labeling, only conveying mode.
<Weighing Continuous>: Weighing of packages with weighing belt running. Default set-
ting.
<Weighing Start/Stop>: Weighing of packages with weighing belt stopped. For long
packages.
Mode level: 1
<Device menu> / <Operating mode>
Press softkey with required operating mode.
20.8.10 Selecting operating mode for labeling belt
This function is used to define whether the labeling belts of devices with two labelers
should run permanently or in start
-stop mode. The following settings are possible:
<LC 1 contin. LC 2 con-
tin.>:
Both labelers in permanent operation. Default setting.
<LC 1 stop LC 2 con-
tin.>:
Labeling belt 1 (LB1) in start-stop mode and existing second la-
beling belt (LB2) in permanent operation.
<LC 1 stop LC 2 stop>: Both labeling belts in start-stop mode.
Operating mode for weighing belt: <Weighing Start/Stop>
Mode level: 1
<Device menu> / <Transport equipment> / <Labeler conv. mode>
Press softkey for the operating mode you want.
To Next Page
Loading...
Need help?
General
