Instruction manual GLM-I Weights and ingredients
38.019.129.001 en 149
13
13.5.10 Selecting weight indication for display and print
The function is described in chapter "Setting display and keyboard layout", see page 98.
You can also enter this setting, providing the database has been config-
ured respectively
, in label parameter tables.
13.6 Entering tare
Usually, the weight of the packaging of a PLU is saved as the tare value in the PLU data.
Providing it is configured respectively
, it is subsequently called up automatically with the
PLU, see page 149.
This is where you can enter the tare weight for the current production. If necessary, you
can have your input applied to the PLU data.
Mode level: 2
<Article data> / <Weight> / <Tare>
Enter tare.
To save the value in article data, activate field "Save in database" .
If the field is not activated, the tare input is only used for the current production.
Press <OK>.
13.7 Allow or block tare changing on PLU change
Decide here if the tare weight saved for the PLU should be called up when the PLU
changes. The following settings are possible
:
"W/o": No tare change on PLU change.
"With": Tare change on PLU change. Standard setting.
Mode level: 5
<Main menu> / <PLU> / <PLU change> / <Change options>
Touch softkey until required setting is achieved.
13.8 Work out share of ingredients
Depending on the configuration, you can print the difference between the net weight and
the share of ingredients of the PLU on the label
, see page 150. Do this by entering the
ingredient share as a percentage or as an absolute value, see page 150.
The different is either printed in addition to the net weight or as a price-relevant weight with
the addition"Meat proport." or "Drained weight" instead of the net weight, see page 150.
To Next Page
Loading...
Need help?
General
