Bizerba GLM-I - Inserting the Label Roll

Accessories Instruction manual GLM-I
438 38.019.129.001 en
31
31.10.1 Inserting the label roll
Before inserting a new label roll, set the label dispenser to "PAUSE" or
switch it off using the mains switch.
Illustration 91: Insert label roll
Remove the outside guide disk
1
.
Insert the new label roll
13
with labels facing outside.
Feed label strip around auxiliary rolls
3
and dancer arms of unwind unit
2
.
Reattach the outside guide disk
1
.
Swivel dancer arm
4
away from the auxiliary roll
5
.
Feed label strip past the auxiliary roll
5
, pass it between the auxiliary rolls
6
,
through the light barrier
7
to the dispenser tongue
9
.
Place dancer arm
4
again on the auxiliary roll
5
.
Pull the label strip until it reaches the take-up pin
12
.