Date and time Instruction manual GLM-I
196 38.019.129.001 en
16
16.5.9 Select time format
Determine here how the packed-on and sell-by time is printed in the respective date fields
of the customer labels. The following settings are possible
:
"Hours": Print hours only.
"Hrs:Min": Print hours and minutes.
Mode level: 2
<Date> / <Print date/time> / <Time format>
Tap the soft key until the required setting is highlighted.
16.5.10 Switch on/off printing time
This is where you can switch printing of the time for date 1 and date 2 either on or off. The
following settings are possible
:
"no": Do not print time.
"With": Print time.
Mode level: 2
<Date> / <Print date/time> / <Select time>
Tap the <Print of Time 1> or <Print of Time 2> softkey until the setting you want is
visible.
16.5.11 Further print settings
Further settings relevant to printing date and time can be made by Bizerba Service. These
relate to:
–
deviation from printed reference date and system date
– updating reference date when switching device on
– continuing date and time
– calculation of date 1 to date 3 from shelf-life days
– calculation sell-by and use-by dates when the shelf-life is zero
For further information please contact your Bizerba consultant or Bizer-
ba Service.
To Next Page
Loading...
