Instruction manual GLM-I Customer specific functions
38.019.129.001 en 109
10
10.4.3 Play macro
Key programming is approved, see page 102.
Macro is available in current mode level.
Starting macro
The following describes the start of a macro per key. As an alternative you can start the
macro also via function "List macros
", see page 111.
Press <Record>.
Press key assigned to macro.
If the macro is protected with a password: Enter password and confirm.
The operating procedure saved by the macro is started. The following symbol ap-
pears on the screen during running: .
If the macro pauses for character input: enter character and press <OK>.
After macro is completed, the macro symbol on the display disappears.
Cancelling macro
A running macro can be cancelled at any time.
Press <Shift> and <Record>.
Select and confirm "Abort macro".
Set play delay
You can have the macro played after a delay for test purposes or in order to extend a mac-
ro. Enter a suitable play delay before the start
. Whenever it is played, after each operating
step, a pause is inserted to the length of the set play delay.
Press <Shift> and <Record>.
Go to the macro menu and select "Recording delay" and confirm.
Enter and confirm the play delay in milli-seconds.
After the test or after processing, enter a play delay of "0" to enable the
macros to be run without a delay
.
To Next Page
Loading...
Need help?
General
