Instruction manual GLM-I Weight classes and statistics
38.019.129.001 en 319
23
23.1.10 Edit the current weight class table
To change the data in the current weight class table, you can open the table, as described
below, and edit it as a whole.
Alternatively, you can make use of the Input Assistant, which restricts your options to the
selections relevant to the preselected type of statistic (selection criterion). The data en-
tered via the Input Assistant are inserted automatically into the current weight class table,
see page 320.
You can use the modified data for the current labeling job if you wish, or save them under
a weight class number in the database.
License "FPV" is available.
Mode level: 2
<Processing> / <Weight class &statistic.> / <Etc> / <Weight class editor>
Edit data, see page 313.
Close weight class table, see page 85.
To save the modified weight class table for the current labeling job only, reply to the
security check with <yes>.
or
To have the modified weight class table applied to the database, reply to the security
check with <Yes, also in database>.
When applying to the database: Depending on the configuration, enter and confirm
the password for mode level 3
(local) or model level 4 (global).
When applying to the database: Enter and confirm the weight class number, see
page 77.
To Next Page
Loading...
