Instruction manual GLM-I Troubleshooting
38.019.129.001 en 363
25
25.5.4 Test scales
You can activate a variety of scale test modes in order to test the scales.
For further information please contact your Bizerba consultant or Bizer-
ba Service.
Mode level: 5
<Service menu> / <Automat> / <Developer param. scale>
Enter and confirm the number of the scale test mode.
25.5.5 Check if within permissible verification limits
This function tests the verification error limits.
This test is usually performed by Bizerba Service. For further informa-
tion please contact your Bizerba consultant or Bizerba Service
.
Mode level: 5
<Service menu> / <Automat> / <Verifiy article>
Perform the test procedure in accordance with the instructions on the screen.
25.6 Delete remote soft keys
A higher-ranking EDP system can assign the softkey of the device for its own purposes. If
a softkey is pressed, in this case, the result goes directly to the EDP system. In the event
of a fault, it might be necessary to delete the softkeys assigned to the EDP system and to
switch off the online connection
. Afterwards, the device can be operated directly again.
When data are transmitted to the EDP system and the connection is in-
terrupted, you have to deselect the affected EDP channel in order to
continue processing
, see page 419.
Mode level: 5
<Interfaces> / <Etc> / <Del. remote softkeys>
To Next Page
Loading...
Need help?
General
