Instruction manual GLM-I Article data
38.019.129.001 en 135
12
The configuration of the database is not subject of this documentation.
For further information please contact your Bizerba consultant or Bizer-
ba Service.
12.3.1 Select arity of PLU and customer number
These functions are used to define the arity of the PLU and customer number. You can
deactivate using the customer number to access a PLU if you like by applying the
"Without
customer number" setting.
At least two places are needed for the PLU and customer number (if activated).
It depends on the configuration of the underlying number key how many digits can be set
in maximum. The number key can be set in an alphanumeric way with up to 20 digits or in
a numeric way with up to 9 digits.
The configuration of the number key is not subject of this documenta-
tion. For further information please contact your Bizerba consultant or
Bizerba Service.
Mode level: 5
<Main menu> / <PLU> / <PLU number>
Select the number of digits and confirm.
The set number of digits appears on the softkey.
<Main menu> / <PLU> / <Customer number>
Select the number of digits and confirm.
The set number of digits appears on the softkey.
12.3.2 Select type of PLU change
You can influence the sequence of the input fields when calling-up article. The following
settings are possible
:
<PLU number>: When accessing a PLU, enter PLU number first. Standard set-
ting.
<Customer number>: Enter customer number first when calling up article.
<W. cust.-no preset>: The customer number entered at last, occurs automatically dur-
ing article call-up. Only if article is to be labeled for a different
customer, the customer number needs to be entered again.
Mode level: 5
<Main menu> / <PLU> / <PLU change> / <PLU-Mode change>
Press softkey with respective setting.
To Next Page
Loading...
