Weight classes and statistics Instruction manual GLM-I
328 38.019.129.001 en
23
23.2.2 Selecting initiation criterion for statistics reports
The statistics reports can be initiated automatically by the device in accordance with preset
criteria. The following initiation criteria are supported:
"Total 1", "Total 2", "Total
3":
The statistics report is triggered when the respective total is
reached.
If you save a statistics with this initiation criterion before the respective
total has been reached
, and open it after having done some labeling in
the meantime, the totals will no longer correspond to the saved statis-
tics. Therefore only use this initiation criterion if you don't need to save
statistical data temporarily.
As an alternative, we recommend using the criterion "Number of accpt.
packages". The number of accepted packages is available again after
reloading and doesn't change in the meantime.
"Number of checked
packages":
Trigger statistics report once entered number of checked pack-
ages is reached
.
"Number of accpt. pack-
ages":
Trigger statistics report once entered number of accepted pack-
ages is reached.
"Time in minutes": Trigger statistics report upon expiry of time entered in minutes.
"Change Charge num-
ber":
Trigger statistics report when batch number is changed.
"Article change",
"Change PLU no.",
"Change customer no.":
What happens when an article is changed or when an article or
customer number is changed is determined in these table rows.
Whether the initiation criterion "Article change" or the criterion
"Change PLU no." and "Change customer no." are approved
depends on how your database is configured.
The configuration of the database is not subject of this documentation.
For further information please contact your Bizerba consultant or Bizer-
ba Service.
To Next Page
Loading...
Need help?
General
