Instruction manual GLM-I Totals
38.019.129.001 en 287
22
22.2 General total preselections
22.2.1 Selecting the preselection type for Total 1 to 3
This is where you define the size to trigger the total memory locations 1 to 3. If the defined
size reaches a preset value
, the total label is printed. The total is deleted in correspond-
ence with the total delete criteria, see page 291.
Example: Total memory 3.The procedure for total memory 1 and 2 is largely the same. We
make references to any discrepancies in the description.
The following settings are supported for total memory 3:
<*3:Preselect pieces>: A preset piece number triggers total 3. The same applies to to-
tal memory 1 and 2.
<*3:Preselect weight>: A preset weight total triggers total 3. The same applies to total
memory 1 and 2.
<*3:Preselect price>: A preset price total triggers total 3. The same applies to total
memory 1 and 2.
<*3:Secondary price>: A preset secondary price total triggers total 3. The same applies
to total memory 1 and 2.
<*3:Number of total 1>: The total memory counts the trigger for total 1. In the event of a
preset number, total 3 is triggered. The same applies to total
memory 2.
<*3:Number of total 2>: The total memory counts the trigger for total 2. In the event of a
preset number, total 3 is triggered. This only applies to total
memory 3.
<*3:Pres.via si.numer-
at.>:
The final total of the single numerator triggers the message "To-
tal 3 reached". When this setting is used,
<Clear single numer.by *3> should also be set, see page 281.
This only applies to total memory 3.
Mode level: 2
<Configure total> / <Presel. total> / <Presel.type total 3>
or
<Processing> / <Presel. total> / <Presel.type total 3>
Press softkey with respective setting.
To Next Page
Loading...
