Bizerba GLM-I - Switching on or off Weight History

Instruction manual GLM-I Setting display and keyboard layout
38.019.129.001 en 93
8
Example: Total window 1. Settings and procedures for total windows 2 and 3 are analog.
The following totals can be displayed in the total window 1
:
– <#1: Total 1>
– <#1: Total 2>
– <#1: Total 3>
– <#1: Article total>
– <#1: Prod- group total>
– <#1: Daily total>
– <#1: Tare total>
– <#1: *1 of act. presel.col.> (Total 1 of current total preselection column)
– <#1: *2 of act. presel.col.> (Total 2 of current total preselection column)
– <#1: Total display tool> (total defined in total display tool)
In addition, the following settings are possible for total window 1:
<#1: W/o 1st tot.win-
dow>:
1st total window not displayed.
<#1: Remote labels>: Number of remote labels to be printed is displayed (with total
printouts).
Mode level: 2
The total window is only visible if the display format
<Text&totals display> is set, see
page 91.
Set total display for total window 1
<Etc> / <eService displ.only> / <1st total window>
Press softkey with respective setting.
The activated softkey is highlighted with a dark bar.
8.8 Switching on or off weight history
The weight history indicates the last determined weights. Depending on the configuration it
is displayed in the text and total display
.
The weight history can be shown or hidden through the function descri-
bed in the following
, if it is activated in GT-SoftControl.
The operation of GT-SoftControl is not subject of this documentation.
Read the operating instructions on GT-SoftControl.
The following settings are possible:
– "W/o"
– "With"
The weight history is activated in program GT-SoftControl.
Mode level: 2