Accessories Instruction manual GLM-I
436 38.019.129.001 en
31
The pressure of the label pressure roller can be increased by inserting washers. Up to
three mounting rails can be mounted
(see figure on the left). If the labeler position
changes, the label pressure roller can be fastened to one of the mounting rails depending
on the labeler position. Only one label pressure roller can be mounted at the required posi-
tion.
Illustration 88: View: pressure roller
Applications
The label pressure roller is only suitable for top labeling of almost even or slightly curved
surfaces with little height difference between the individual packages
.
31.10 Label dispenser
If a label dispenser is mounted to the con-
veyor unit of the device, it can be used to
apply preprinted labels to the packages
.
Possible use
Additional application of the following labels
to packages:
– Decorative labels
– Campaign labels
– Other preprinted labels
Illustration 89: View: label dispenser
To Next Page
Loading...
