Display and operating unit Instruction manual GLM-I
78 38.019.129.001 en
7
Select required data record and confirm.
The parameter number of the data record is entered in the input field.
7.7.2 Creating parameter tables and opening them for editing
For administrating parameter tables the matching menus contain functions. The respective
chapters contain information on how to call up for editing
, for example calling up a label
parameter table in chapter Manage label parameters in tables.
General procedure on how to create a new parameter table
Press softkey for editing a parameter table.
When recording a parameter number select a free parameter number or make setting
via <Next availb. no.> and confirm
, see page 77.
or
First open an existing parameter table, edit it and save it then under a free parameter
number before closing it
. To do so, record a free parameter number or set via
<Next availb. no.>, see page 77.
A new parameter table is created.
General procedure on how to edit an existing parameter table
Press softkey for editing a parameter table.
Record parameter number of required table or select via selection key, see page 77.
Before closing save table under same parameter number.
The previous content of the parameter table is replaced through the new entries.
To Next Page
Loading...
