Instruction manual GLM-I Weight classes and statistics
38.019.129.001 en 311
23
23.1.2 Define or edit weight class table
Mode level: 3 (local) or 4 (global)
<Weight class> / <Weight class data>
To create a new weight class table, record new weight class number and confirm, see
page 77.
or
To open an existing weight class table for editing, enter number of required weight
class and confirm, see page
77.
Enter or change weight class data in the displayed weight class table, see page 313.
Close weight class table, see page 85.
To save the weight class table in the database, answer the security check with <yes>.
Enter and confirm the weight class number, see page 77. The weight class number
that is entered when the weight class table is opened is preset
.
The weight class table is saved under the specified weight class number in the database.
23.1.3 Set up weight class columns
Define a weight range for each weight class.
Example: Three weight classes. Default setting
. Nominal weight 200 g.
Lower weight class less than 190 g
Middle weight class 190 g to 210 g
Upper weight class more than 210 g
You can deactivate the right weight class if you want, by entering a
weight range of 0 g. The bordering column is automatically adjusted to
ensure that there are no gaps
.
A weight class table has been opened in the editor.
Select weight field in the first weight class column.
Enter upper weight limit (in example: 190) and confirm your input.
Repeat this procedure for more weight class columns.
In the last weight class column, the weight range is entered automatically, in the example:
210.
To Next Page
Loading...
Need help?
General
