Instruction manual GLM-I Setting display and keyboard layout
38.019.129.001 en 97
8
8.9.4 Displaying numerical data
In display format <L3: Small diagr. display> statistics data are listed in numeric order, see
page 91.
The function <Statistics: num. data> is without function in combination
with the display and operating terminal GT
-12C.
It depends on the respective setting in GT-SoftControl if the numeric
display is indicated or not
.
The operation of GT-SoftControl is not subject of this documentation.
Read the operating instructions on GT-SoftControl.
8.9.5 Setting value range for display-optimized statistics
Use this function to set the value range for statistics display in a way that an optimal
screen layout is achieved
. The limit values entered are adapted automatically for the histo-
gram display to ensure that nine equal bars are created.
The device only displays the display-optimized statistics. It does not export the data.
Mode level: 2
<Processing> / <Weight class &statistics> / <Statistics display> /
<Display opt. statist.>
Enter lower limit.
Enter upper limit.
Save table and exit, see page 85.
8.9.6 Resetting display-optimized statistics
The display-optimized statistics is only displayed but not provided as a statistics report.
Therefore, the data of the display-optimized statistics is not deleted automatically
. Article
changes do not influence the statistics display. After an article or batch change the display
statistics needs to be reset manually. The values of the previous packages are released
through resetting.
Mode level: 2
<Processing> / <Weight class &statistics> / <Statistics display> /
<Reset displ. opt.statist.>
To Next Page
Loading...
Need help?
General
