Bizerba GLM-I - Power supply; Operating conditions

Instruction manual GLM-I Technical data
38.019.129.001 en 465
32
The rotary arm labeler does not require any customer-sided com-
pressed air supply
. The vacuum for the rotating labeler arm is gener-
ated by a vacuum pump in the device.
Depending on the version, the devices are equipped with a compressed
air reducer with water separator
. Please see your order confirmation for
the precise delivery date.
32.4 Power supply
GLM-I 40 GLM-I 70 GLM-I 100 GLM-I 150 GLM-I 170
230 V AC
50-60 Hz
2.4 A 2.4 A 2.4 A 2.4 A 2.4 A
240 V AC
50 Hz
2.4 A 2.4 A 2.4 A 2.4 A 2.4 A
110 V AC
60 Hz
4 A 4 A 4 A 4 A 4 A
Supply line: Length approx. 2.5 m with 5-pin CEE connector
, 16 A.
32.5 Operating conditions
The device must not be installed and put into operation if the following operating conditions
are not met:
Device
family
Ambient temperature
°C (degF)
Relative humidity %
Operation Storage Operation Storage
min. max. min. max. min. max. min. max.
EDP
sys-
tems
+15 (+60) +30 (+87) -10 (+14) +43 (+109) 8 80 20 80
Scale -5 (+104) +40 (+104) -20 (-4) +60 (+140) – 90 –
Printer -5 (+104) +40 (+104) -20 (-4) +60 (+140) – 90 – 90