Instruction manual GLM-I Labeling systems
38.019.129.001 en 51
6
6.4.1 Switching off vacuum set of gripper
With the piston labeler the printed label is removed from the printer with a gripper and con-
veyed under the labeling piston. The label is hold with 2 vacuum jets at the gripper. If small
labels or decorative labels with an oddly-shaped outer form is used, with which the right
vacuum jet is not covered through the label, this vacuum jet can be switched off.
Illustration 13: Lock bolts on labeling system
Open the right side door of the labeler
and turn away to the right.
Press in lock bolt
, pull the labeling
system and swivel to the left.
There is a switch on the back of the la-
beling system to switch on and off the
vacuum.
Illustration 14: Switching off the vacuum jet
Turn switch
to OFF.
The right vacuum jet has been switched
off.
Swivel back labeling system and lock it.
6.5 EcoMotion Printer: adjusting pressure rollers to width of back-
ing paper
Set the pressure rollers so that both pressure rollers are at the same distance to the side
edge of the backing paper.
Only for devices with EcoMotion printing mechanisms.
Processing is stopped
.
Open the right side door of the labeler and swivel it to the right.
To Next Page
Loading...
