Bizerba GLM-I - Only Send Valid or also Faulty Package Data to the Higher-Ranking; EDP System

Instruction manual GLM-I Interfaces
38.019.129.001 en 413
30
30.6.7 Only send valid or also faulty package data to the higher-rank-
ing EDP system
This is where you determine whether package-synchronous data are sent to the higher-
ranking EDP system for all packages or only for valid packages. The following settings are
possible:
"Valid": Only package-synchronous data for valid packages (PSV_DA-
TA) are sent to the EDP system. Standard setting.
"All": The package-synchronous data for valid packages (PSV_DA-
TA) and the package-synchronous data for faulty packages
(PSV_ERRDATA) are also sent to the EDP system.
Mode level: 5
<Interfaces> / <Outgoing lines> / <Packages f. PSV DATA>
Tap the softkey until the required setting is highlighted.