Bizerba GLM-I - Select Send Single Package Data to Higher-Ranking EDP System; Tent of PSV_DATA); Select Send Data on Change

Interfaces Instruction manual GLM-I
412 38.019.129.001 en
30
30.6.5 Select Send single package data to higher-ranking EDP sys-
tem (content of PSV_DATA)
In the "Contents of PSV_DATA" table (package-synchronous data), select the single pack-
age data you want sent to the higher-ranking EDP system.
In the standard setting, only valid package data are sent to the EDP system after the pack-
ages have been checked. If necessary, you can transfer the data from faulty packages, in
respectively identified data records, see page 413.
The transferred package data can be found in annex, see page 497.
Mode level: 5
<Interfaces> / <Outgoing lines> / <Contents of PSV_DATA>
Allocate the data you want to channels A and B.
Close table.
30.6.6 Select Send data on change
In the "Send if data is mod." table you determine which data and commands are sent to
which channel when changed manually or via an interface
.
The available data and commands can be found in the annex, see
page 497.
Mode level: 5
<Interfaces> / <Outgoing lines> / <Send if data is mod.>
Make settings.
Close table.