Instruction manual GLM-I Customer specific functions
38.019.129.001 en 107
10
Include input of a value during a macro
Start function that requires input of a value during the ongoing recording.
Press <Shift> and <Record>.
The macro menu appears.
Select and confirm "Recording pause".
The screen indicates that the recording is on hold by the following icon:
. During
the break, work can continue in the current or lower menu levels
. These operating
steps are not recorded.
To continue recording, move into a higher menu level.
When the macro is started, it awaits an input at this point.
Change numeric values via macro
Start a function to change a value during a running recording.
Press the arrow key x-times <upwards> in order to increase the value x-times.
or
Press the arrow key x-times <downwards> in order to decrease the value x-times.
or
Enter value.
Switch Soft key by macro
Use the shortcuts described below to change the settings of switchable softkeys by macro.
This is the only procedure in which the macro can be set as you want
, independent of the
respective presetting.
<Press 2nd> and softkey at the same time, to select the left softkey setting.
or
<Press Shift> and softkey at the same time, to select the right softkey setting.
Select setting from a selection list
Start a function that requires a setting for each selection menu during the running re-
cording.
Press <Shift> and the <Up> arrow key to move the cursor to the first entry. This is
important in order to mark a clear starting position for the subsequent movement of
the cursor.
Press the <Down> arrow key repeatedly until you have reached the setting you want.
Press <OK>.
To Next Page
Loading...
Need help?
General
