Instruction manual GLM-I Processing
38.019.129.001 en 285
21
The settings for the print channels can also be made in the PLU data, so that they auto-
matically appear when the PLU is changed
, see page 132.
This function allows to enter or change the current labeling process settings. The settings
are not saved in the database. The following settings are possible:
"always active": Labeler is always active.
"not active": Labeler is always off.
"active when special
price":
Labeler is active in case of special price.
"not active when special
price":
Labeler is not active in case of special price.
"Pair1 (start) change on
paper end":
The labelers of pair 1 change at paper end. The labeler with this
setting starts.
"Pair1 (Standby) Change
on paper end":
The labelers of pair 1 change at paper end. The labeler with this
setting is on standby first. The other labeler of pair 1 starts.
"Pair1 (start) alternated
after each package":
The labelers of pair 1 change after each package. The labeler
with this setting starts.
"Pair1 (Standby) alternat.
after each package":
The labelers of pair 1 change after each package. The labeler
with this setting is on standby first. The other labeler of pair 1
starts.
The same settings as for pair 1 are available for pair 2 and 3.
Example:
Setting for channel A
(first labeler):
"Pair1 (start) change on paper end"
Setting for channel B
(second labeler):
"Pair1 (Standby) Change on paper end"
Channel A prints until paper end is reported. Automatic switching to channel B. Channel B
prints until there is no more paper.
Mode level: 2
<Processing> / <Print chan. control>
Make the desired print channel settings in the table.
Exit table, see page 85.
To save modified settings answer the security query with <yes>.
To Next Page
Loading...
