Contents Instruction manual GLM-I
12 38.019.129.001 en
20.2 Labeler adjustment ............................................. 252
20.2.1 Activating and deactivating the height adjustment for labelers ...... 252
20.2.2 Activating and deactivating the transverse adjustment for labelers .. 252
20.2.3 Setting the height offset of the labeler ............................ 253
20.2.4 Setting the transverse offset of the labeler ........................ 253
20.2.5 Enter the maximum package height .............................. 254
20.2.6 Adjusting labeler height by means of softkeys ..................... 254
20.2.7 Enter transverse position of labeler ............................... 255
20.2.8 Adjusting the transverse position of the labeler via softkeys ........ 255
20.3 Distances and positions of the labeler ............................ 256
20.3.1 Entering the label distance ...................................... 256
20.3.2 Enter reference line for label distance ............................ 257
20.4 Piston labeler ................................................... 257
20.4.1 Entering package height ......................................... 258
20.4.2 Entering gripper offset ........................................... 258
20.4.3 Entering rotational angle ........................................ 259
20.4.4 Entering acceleration time ....................................... 259
20.4.5 Entering extension time ......................................... 259
20.5 Rotary arm labeler .............................................. 259
20.5.1 Rotation parameter ............................................. 260
20.6 Belt labeler ..................................................... 260
20.6.1 Entering label overhang ......................................... 260
20.6.2 Entering supporting air supply for roller lift ........................ 260
20.6.3 Entering supporting air supply for gripper ......................... 260
20.6.4 Entering extension time of pressure roller ......................... 261
20.7 Delay for the external triggered labeler ........................... 261
20.8 Conveyor unit .................................................. 261
20.8.1 Switching on or off the auxiliary belts ............................. 261
20.8.2 Registration of light barrier masking section ....................... 262
20.8.3 Selecting transmitting current of light barrier ...................... 262
20.8.4 Entering belt speed for labeling .................................. 263
20.8.5 Registration of belt speed for conveying .......................... 263
20.8.6 Registration of separation factor ................................. 263
20.8.7 Activating or deactivating pressure roller .......................... 263
20.8.8 Entering speed of pressure roller ................................. 264
20.8.9 Selecting operating mode for weighing belt ....................... 264
20.8.10 Selecting operating mode for labeling belt ........................ 264
20.8.11 Adjusting and calibrating guide rails .............................. 265
20.9 Dividers and package ejector .................................... 265
20.9.1 Registration of switch-on time .................................... 265
20.9.2 Selecting polarity ............................................... 266
20.9.3 Selecting activation criteria ...................................... 267
20.9.4 Registration of delay time ........................................ 268
20.9.5 Setting control and container light barrier ......................... 268