Instruction manual GLM-I Contents
38.019.129.001 en 13
20.10 Ejecting package for quality assurance ........................... 268
20.11 Signal lamp for paper status ..................................... 269
20.12 Polarities ....................................................... 269
20.12.1 Setting polarity for control light barriers ........................... 269
20.12.2 Setting polarity for container light barriers ......................... 270
20.12.3 Setting polarity for other inputs and outputs ....................... 270
20.13 Delays ......................................................... 271
20.14 Scale .......................................................... 271
20.14.1 Activate or deactivate tare printing ............................... 271
21 Processing ............................................................ 272
21.1 Configuring resolution for label printing ........................... 272
21.2 Switch on and apply automatic PLU change ...................... 272
21.3 Configure synchronization message of weighing belt .............. 274
21.4 Enter labeling type .............................................. 275
21.5 Configure change of labeling type ................................ 278
21.6 Entering device number ......................................... 278
21.7 Entering device name ........................................... 278
21.8 Enter production numbers ....................................... 279
21.8.1 Switch printing of the operator number on or off ................... 279
21.8.2 Entering operator number ....................................... 279
21.8.3 Configuring batch number ....................................... 280
21.8.4 Entering batch number .......................................... 280
21.8.5 Entering lot number ............................................. 280
21.9 Use numerators ................................................ 281
21.9.1 Configuring individual numerator ................................. 281
21.9.2 Configuring total numerator ...................................... 282
21.9.3 Enter the range of values of the numerators ....................... 283
21.9.4 Editing start value of numerators ................................. 283
21.9.5 Configuring available counters ................................... 284
21.10 Printer channel control .......................................... 284
22 Totals ................................................................. 286
22.1 Set totalization type ............................................. 286
22.2 General total preselections ...................................... 287
22.2.1 Selecting the preselection type for Total 1 to 3 .................... 287
22.2.2 Entering preselection value for total 1 to 3 ........................ 288
To Next Page
Loading...
Need help?
General
