Cisco ONS 15454 DWDM - NTP- G4 Open and Remove the FMEC Cover (ETSI Only)

1-23
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
August 2005
Chapter 1 Install the Shelf and Common Control Cards
NTP-G4 Open and Remove the FMEC Cover (ETSI Only)
Figure 1-8 Removing the ONS 15454 ANSI Front Door
Step 3
Return to your originating procedure (NTP).
NTP-G4 Open and Remove the FMEC Cover (ETSI Only)
Step 1 Complete the “DLP-G11 Open the FMEC Cover” task on page 1-24.
Step 2 Complete the “DLP-G12 Remove the FMEC Cover” task on page 1-25.
Purpose This procedure opens and removes the FMEC cover on the ONS
15454 ETSI. The ONS 15454 ETSI has a screw-in panel over the EFCA.
The FMEC cover protects the FMEC cards.
Tools/Equipment Medium slot-head screwdriver
Prerequisite Procedures NTP-G2 Install the Shelf Assembly, page 1-8
Required/As Needed Required
Onsite/Remote Onsite
Security Level None
Door hinge
Assembly hinge pin
Assembly hinge
Translucent
circles
for LED
viewing
38831
FAN FAIL
CRIT
M
AJ
MIN