Cisco ONS 15454 DWDM - DLP- G148 View OTN PM Parameters

9-25
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 9 Monitor Performance
DLP-G148 View OTN PM Parameters
Step 5 Return to your originating procedure (NTP).
DLP-G148 View OTN PM Parameters
Step 1 In node view, double-click the TXP or MXP card where you want to view PM counts. The card view
appears.
Step 2 Click the Performance > OTN PM > G.709 tabs (Figure 9-8).
Figure 9-8 Viewing OTN ITU-T G.709 Performance Monitoring Information
Purpose This task enables you to view the OTN PM counts on a transponder
(TXP_MR_10G, TXP_MR_2.5G, TXPP_MR_2.5G, TXP_MR_10E),
or muxponder (MXP_2.5G_10E, MXP_2.5G_10G) card and port to
detect possible performance problems.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
96976
Directions
radio buttons
Performance
tab
OTN PM tab
G.709 PM
tab
Card View
Intervals
radio buttons
Help
button
Clear
button
Baseline
button
Auto-refresh
menu
Refresh
button
Signal-type
port menu