Cisco ONS 15454 DWDM - DLP- G208 Change Optical Line Settings for Multiplexer and Demultiplexer Cards

11-25
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 11 Change DWDM Card Settings
DLP-G208 Change Optical Line Settings for Multiplexer and Demultiplexer Cards
Step 4 Click Apply. If the change affects traffic, a warning message displays. Click Yes to complete the
change.
Step 5 Return to your originating procedure (NTP).
Type (Display only) Identifies the type of port. • Input Com
• Output Com
Power (Display only) Shows the current power level per
port.
—
VOA Mode (32DMX only; display only) Shows the functional
mode of the VOA, when present.
• Constant Attenuation
• Constant Power
VOA Power
Ref
(32DMX only; display only) Shows the optical
power setpoint that must be reached when a VOA
is present and VOA Mode is set to Constant Power.
This parameter can only be modified by ANS.
—
VOA Power
Calib
(32DMX only) Modifies the optical power value of
the VOA when VOA Mode is set to Constant
Power.
Numeric. Double-click the parameter, enter a value,
and press Enter.
VOA
ATTenuation
Ref
(32DMX only; display only) Shows the VOA
attenuation value when VOA Mode is set to
Constant Attenuation. This parameter can only be
modified by ANS.
—
VOA
Attenuation
Calib
(32DMX only) Modifies the attenuation value of
the VOA when the VOA Mode is set to Constant
Attenuation.
Numeric. Double-click the parameter, enter a value,
and press Enter.
AINS Soak (Display only) Sets the automatic in-service soak
period.
• Duration of valid input signal, in hh.mm format,
after which the card becomes in service (IS)
automatically
• 0 to 48 hours, 15-minute increments
Table 11-14 Multiplexer and Demultiplexer Card Optical Line Settings (continued)
Parameter Description Options