Cisco ONS 15454 DWDM - DLP- G144 Enable or Disable OTN ITU-T G.709 Performance Monitoring

9-20
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 9 Monitor Performance
DLP-G144 Enable or Disable OTN ITU-T G.709 Performance Monitoring
Step 2 Complete the “DLP-G144 Enable or Disable OTN ITU-T G.709 Performance Monitoring” task on
page 9-20 as needed for any TXP or MXP card (except the TXP_MR_10E and MXP_2.5G_10E cards)
to enable or disable optical transport network (OTN) ITU-T G.709 monitoring.
Step 3 Complete the “DLP-G145 Enable or Disable OTN FEC Performance Monitoring” task on page 9-21 as
needed for TXP_MR_10E and MXP_2.5G_10E cards to enable or disable OTN forward error correction
(FEC) monitoring.
Step 4 Complete the following tasks as needed to view PM parameters:
• DLP-G146 View Optics PM Parameters, page 9-22
• DLP-G147 View Payload PM Parameters, page 9-23
• DLP-G148 View OTN PM Parameters, page 9-25
• DLP-G149 View Payload Statistics PM Parameters, page 9-27
• DLP-G150 View Payload Utilization PM Parameters, page 9-28
• DLP-G151 View Payload History PM Parameters, page 9-30
• DLP-G152 View Payload SONET PM Parameters, page 9-31
Note To refresh, reset, or clear PM counts, see the “NTP-G73 Change the PM Display” procedure on
page 9-2.
Stop. You have completed this procedure.
DLP-G144 Enable or Disable OTN ITU-T G.709 Performance Monitoring
Step 1 In node view, double-click the card you want to monitor. The card view appears.
Step 2 Determine if the port where you want to enable or disable OTN ITU-T G.709 is in service (IS). (Click
the Provisioning > Line tabs, and observe the Service State column for that port.) If it is IS, perform the
following tasks for that port. If not, go to Step 3.
a. DLP-G108 Change the Service State for a Port, page 7-18 to set the port to Out of Service, Disabled
(OOS,DSBLD).
Purpose This task enables or disables OTN ITU-T G.709 monitoring of near-end
or far-end performance on a card and port during selected time intervals
to detect possible problems. This task can be performed for any TXP or
MXP card except the TXP_MR_10E and MXP_2.5G_10E cards. See the
“DLP-G145 Enable or Disable OTN FEC Performance Monitoring” task
on page 9-21 for TXP_MR_10E and MXP_2.5G_10E card information.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher