Cisco ONS 15454 DWDM - DLP- G210 Change Optical Channel Settings for Multiplexer and Demultiplexer Cards; Table 11-17 Multiplexer and Demultiplexer Card Optical Channel Settings

11-28
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 11 Change DWDM Card Settings
DLP-G210 Change Optical Channel Settings for Multiplexer and Demultiplexer Cards
Table 11-17 Multiplexer and Demultiplexer Card Optical Channel Settings
Parameter Description Options
Port # (Display only) Displays the port number. Displays port number and TX or RX.
Port Name Provides the ability to assign the specified port a
name.
User-defined. Name can be up to 32 alphanumeric/
special characters. Blank by default. Double-click,
enter the name, and press Enter.
See the “DLP-G104 Assign a Name to a Port” task on
page 7-10.
Admin State Sets the port service state unless network
conditions prevent the change. For more
information about administrative states, see
Appendix C, “DWDM Administrative and Service
States.”
From the drop-down list, choose one of the following:
• IS/Unlocked
• IS,AINS/Unlocked,automaticInService
• OOS,DSBLD/Locked,disabled
• OOS,MT/Locked,maintenance
Line Direction Provides the ability to associate a card with the line
direction. CTC automatically configures the line
direction during node setup. To change this setting,
you must change the Cisco MetroPlanner site plan
and import it to the node.
From the drop-down list, choose one of the following:
• East to West
• West to East
Service State (Display only) Identifies the autonomously
generated state that gives the overall condition of
the port. Service states appear in the format:
Primary State-Primary State Qualifier, Secondary
State. For more information about service states,
see Appendix C, “DWDM Administrative and
Service States.”
• IS-NR/Unlocked-enabled
• OOS-AU,AINS/Unlocked-disabled,
automaticInService
• OOS-MA,DSBLD/Locked-enabled,disabled
• OOS-MA,MT/Locked-enabled,maintenance
Type (Display only) Identifies the type of port.
• ADD
• DROP
Power (Display only) Shows the current power level per
port.
—
VOA Mode (Display only; 32MUX-O, 32DMX-0, 4MD only)
Shows the current functional mode of the VOA.
• Constant Power
• Constant Attenuation
VOA Power
Ref.
(Display only; 32MUX-O, 32DMX-0, 4MD only)
Shows the Power setpoint that must be reached on
the path where a VOA is present when the VOA
Mode is Constant Power.
Demultiplexers show the reference value of the
desired optical power going to the client.
Multiplexers show the reference value of the
desired per-channel optical power. This parameter
can only be modified by ANS.
—