9-10
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 9 Monitor Performance
DLP-G139 View Optical Service Channel PM Parameters
• DLP-G276 View 4-Channel Multiplexer/Demultiplexer Optical Power Statistics, page 9-15
• DLP-G142 View Channel Optical Add/Drop Multiplexer Power Statistics, page 9-16.
• DLP-G143 View Band Optical Add/Drop Multiplexer Power Statistics, page 9-18.
Note To refresh, reset, or clear PM counts, see the “NTP-G73 Change the PM Display” procedure
on page 9-2.
Stop. You have completed this procedure.
DLP-G139 View Optical Service Channel PM Parameters
Step 1 In node view, double-click the OSCM or OSC-CSM card where you want to view PM counts. The card
view appears.
Step 2 Click the Performance > OC3 Line tabs (Figure 9-1).
Purpose This task enables you to view optical service channel (OSC) PM counts
at selected time intervals on an OSCM or OSC-CSM card and port to
detect possible performance problems.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
To Next Page
Loading...
