Cisco ONS 15454 DWDM - NTP- G137 Export Network Element Defaults

13-44
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 13 Maintain the Node
NTP-G137 Export Network Element Defaults
Note Changes to most node defaults reprovision the node when you click Apply. Changes made to
card settings using the Defaults Editor do not change the settings for cards that are already
installed or slots that are preprovisioned for cards, but rather, change only cards that are installed
or preprovisioned thereafter. To change settings for installed cards or preprovisioned slots, see
Chapter 11, “Change DWDM Card Settings.” To change settings for transponder or muxponder
cards see Chapter 5, “Provision Transponder and Muxponder Cards.”
Note Changing some NE defaults can cause CTC disconnection or a reboot of the node in order for
the default to take effect. Before you change a default, view the Side Effects column of the
Defaults editor (right-click a column header and select Show Column > Side Effects) and be
prepared for the occurrence of any side effects listed for that default.
Stop. You have completed this procedure.
NTP-G137 Export Network Element Defaults
Note The defaults currently displayed are exported whether or not they have been applied to the current node.
Note The NE defaults can also be exported from the File > Export menu. These exported defaults are for
reference only and cannot be imported.
Note For a list of NE defaults, see Appendix D, “Network Element Defaults.”
Step 1 Complete the “DLP-G46 Log into CTC” task on page 2-25 at the node where you want to export NE
defaults.
Step 2 Click the Provisioning > Defaults editor tabs.
Step 3 Click Export.
Step 4 If the location where you want to export the file does not appear in the Export Defaults to File dialog
box, click Browse and browse to the location.
Step 5 Change the file name to something that is easy to remember (the file name has no extension).
Purpose This procedure exports the NE defaults using the NE Defaults editor. The
exported defaults can be imported to other nodes.
Tools/Equipment None
Prerequisite Procedures None
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser