5-58
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 5 Provision Transponder and Muxponder Cards
DLP-G306 Provision the TXP_MR_2.5G and TXPP_MR_2.5G Cards Client Port Alarm and TCA Thresholds
Step 8 Under Types, click the Alarm radio button and click Refresh.
Step 9 Provision the trunk port (Port 2) Alarm thresholds for RX Power High to –7 dBm and the RX Power Low
to –26 dBm.
Step 10 Click Apply.
Step 11 Click the 1 Day PM interval radio button, click Refresh, then repeat Steps 6 through 10 for the 1-day
interval. If you have completed both intervals, continue with Step 12.
Step 12 Return to your originating procedure (NTP).
DLP-G306 Provision the TXP_MR_2.5G and TXPP_MR_2.5G Cards Client Port
Alarm and TCA Thresholds
Step 1 In node view, double-click the TXP_MR_2.5G or TXPP_MR_2.5G card where you want to change the
client port alarm and TCA settings.
Step 2 Click the Provisioning > Optics Thresholds tabs. The TCA thresholds are shown by default.
Step 3 Referring to Table 5-35, provision the Port 1 (client) TCA thresholds for RX Power High, RX Power
Low, TX Power High, and TX Power Low based on the client interface at the other end. For additional
information about client SFP and XFP interfaces, also known as PPMs, refer to Appendix B, “Hardware
Specifications.”
Note Do not modify the Laser Bias parameters.
Note You must modify 15 Min and 1 Day independently. To do so, choose the appropriate radio button
and click Refresh.
Table 5-34 TXP_MR_2.5G and TXPP_MR_2.5G Trunk Port TCA Thresholds
Signal TCA RX Power Low TCA RX Power High
3R –23 dBm –9 dBm
2R –24 dBm –9 dBm
Purpose This task provisions the client port alarm and TCA thresholds for the
TXP_MR_2.5G and TXPP_MR_2.5G cards.
Tools/Equipment None
Prerequisite Procedures DLP-G278 Provision the Optical Line Rate, page 5-6
DLP-G46 Log into CTC, page 2-25
Required/As Needed Required
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
