10-9
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 10 Manage the Node
NTP-G134 Modify OSI Provisioning
NTP-G134 Modify OSI Provisioning
Note Additional information about the ONS 15454 implementation of OSI is provided in the “Management
Network Connectivity” chapter of the Cisco ONS 15454 Reference Manual.
Step 1 Complete the “DLP-G46 Log into CTC” task on page 2-25. If you are already logged in, continue with
Step 2.
Step 2 Complete the “NTP-G103 Back Up the Database” procedure on page 13-2.
Step 3 Perform any of the following tasks as needed:
• DLP-G284 Modify the TARP Operating Parameters, page 10-10
• DLP-G285 Add a Static TID to NSAP Entry to the TARP Data Cache, page 10-12
• DLP-G286 Remove a Static TID to NSAP Entry from the TARP Data Cache, page 10-12
• DLP-G287 Add a TARP Manual Adjacency Table Entry, page 10-13
• DLP-G292 Remove a TARP Manual Adjacency Table Entry, page 10-13
• DLP-G293 Change the OSI Routing Mode, page 10-14
• DLP-G294 Edit the OSI Router Configuration, page 10-15
• DLP-G295 Edit the OSI Subnetwork Point of Attachment, page 10-16
• DLP-G296 Edit an IP-Over-CLNS Tunnel, page 10-17
• DLP-G297 Delete an IP-Over-CLNS Tunnel, page 10-18
Step 4 Complete the “NTP-G103 Back Up the Database” procedure on page 13-2.
Stop. You have completed this procedure.
Purpose This procedure modifies the ONS 15454 OSI parameters including the OSI
routing mode, TARP, routers, subnets, and IP-over-Connectionless
network service (CLNS) tunnels.
Tools/Equipment None
Prerequisite Procedures NTP-G132 Provision OSI, page 3-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
