Cisco ONS 15454 DWDM - Table 5-32 TXP_MR_2.5 G and TXPP_MR_2.5 G Transponder Card Line Thresholds Settings for OC-3;STM-1, OC-12;STM-4, and OC-48;STM-16 Payloads

5-55
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 5 Provision Transponder and Muxponder Cards
DLP-G232 Change TXP_MR_2.5G and TXPP_MR_2.5G Cards Line Threshold Settings for SONET or SDH Payloads
Step 4 Click Apply.
Step 5 Return to your originating procedure (NTP).
Table 5-32 TXP_MR_2.5G and TXPP_MR_2.5G Transponder Card Line Thresholds Settings
for OC-3/STM-1, OC-12/STM-4, and OC-48/STM-16 Payloads
Parameter Description Options
Port (Display only) Port number
• 1
• 2
• 3 (TXPP_MR_2.5G card only)
CV Coding violations Numeric. Can be set for Near End or Far
End, for 15-minute or one-day intervals,
or for Line (Far End only), Section, or
Path. Select the bullet and click Refresh.
ES Errored seconds Numeric. Can be set for Near End or Far
End, for 15-minute or one-day intervals,
or for Line (Far End only), Section, or
Path. Select the bullet and click Refresh.
SES Severely errored seconds Numeric. Can be set for Near End or Far
End, for 15-minute or one-day intervals,
or for Line (Far End only), Section, or
Path. Select the bullet and click Refresh.
SEFS (Section only) Severely errored framing
seconds
Numeric. Can be set for Far End, for
15-minute or one-day intervals for
Section only. Select the bullet and click
Refresh.
FC (Line only) Failure count Numeric. Can be set for Near End or Far
End, for 15-minute or one-day intervals
for Line only. Select the bullet and click
Refresh.
UAS (Line only) Unavailable seconds Numeric. Can be set for Near End or Far
End, for 15-minute or one-day intervals,
for Line only. Select the bullet and click
Refresh.