4-50
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 4 Perform Node Acceptance Tests
DLP-G90 Verify an AD-xB-xx.x Pass-Through Connection Power
Step 14 (Optional) Perform one of the following:
• If an OSCM card is installed, connect a power meter to LINE TX port on the card front panel and
verify that the east OPT-BST amplifier is turned on by the pass-through wavelength.
• If an OSC-CSM card is installed, complete the “DLP-G84 Verify the OSC-CSM Incoming Power”
task on page 4-44 for the east OSC-CSM card.
Step 15 Return to your originating procedure (NTP).
DLP-G90 Verify an AD-xB-xx.x Pass-Through Connection Power
Step 1 Verify the east AD-xB-xx.x band TX power:
a. Display the east AD-xB-xx.x card in card view.
b. Click the Provisioning > Optical Band > Parameters tabs.
c. Change the Admin State of the BAND TX (east-to-west) port related to the wavelength selected on
the tunable laser to OOS,MT (ANSI) or Locked,maintenance (ETSI). Click Apply.
d. Verify that the BAND TX port Power value is higher than the default no-power value of –30 dBm.
Step 2 Verify the west AD-xB-xx.x card RX and TX power:
a. Display the west AD-xB-xx.x card in card view.
b. Click the Provisioning > Optical Band > Parameters tabs.
c. Verify that the Power value of the BAND RX (east-to-west) port is higher than the default no-power
value of –30 dBm.
d. Change the Admin State of the BAND TX (west-to-east) port related to the wavelength selected on
the tunable laser to OOS,MT (ANSI) or Locked,maintenance (ETSI). Click Apply.
e. Verify that the BAND TX port Power value is higher than the default no-power value of –30 dBm.
Step 3 Verify the band RX port on the east AD-xB-xx.x card:
a. Display the east AD-xB-xx.x card in card view.
b. Click the Provisioning > Optical Band > Parameters tabs.
c. Verify that the Power value of the BAND RX (west-to-east) port is higher than the default no-power
value of –30 dBm.
Step 4 Return to your originating procedure (NTP).
Purpose This task verifies an AD-xB-xx.x pass-through connection.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser
To Next Page
Loading...
