13-6
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 13 Maintain the Node
DLP-G248 Use the Reinitialization Tool to Clear the Database and Upload Software (Windows)
Note The ONS 14545 Software CD is if the Reinit.jar file, the CISCO 15454 package file, and the NE
default file are not stored on your computer.
Step 1 Insert the ONS 15454 System Software CD, Version 6.0, into the computer CD-ROM drive. If the CTC
Installation Wizard appears, click Cancel.
Step 2 From the Windows Start menu, choose Run. In the Run dialog box, click Browse and navigate to the
CISCO15454 or CISCO15454SDH folder on the software CD.
Step 3 In the Browse dialog box Files of Type field, choose All Files.
Step 4 Choose the RE-INIT.jar file and click Open. The NE Re-Initialization window appears (Figure 13-2).
Figure 13-2 Reinitialization Tool
Step 5 Complete the following fields:
• GNE IP—If the node you are reinitializing is accessed through another node configured as a
gateway network element (GNE), enter the GNE IP address. If you have a direct connection to the
node, leave this field blank.
• Node IP—Enter the node name or IP address of the node that you are reinitializing.
• User ID—Enter the user ID needed to access the node.
• Password—Enter the password for the user ID.
• Upload Package—Check this box to send the software package file to the node. If unchecked, the
software stored on the node is not modified.
• Force Upload—Check this box to send the software package file to the node even if the node is
running the same software version. If unchecked, reinitialization will not send the software package
if the node is already running the same version.
• Activate/Revert—Check this box to activate the uploaded software (if the software is a later than
the installed version) or revert to the uploaded software (if the software is earlier than the installed
version) as soon as the software file is uploaded. If unchecked, the software is not activated or
reverted after the upload, allowing you to initiate the functions later from the node view
Maintenance > Software tab.
• Re-init Database—Check this box to send a new database to the node. (This is equivalent to the CTC
database restore operation.) If unchecked, the node database is not modified.
• Confirm—Check this box if you want a warning message displayed before any operation is
performed. If unchecked, reinitialization does not display a warning message.
To Next Page
Loading...
Need help?
General
