10-30
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 10 Manage the Node
DLP-G173 Enable Dialog Box Do-Not-Display Option
Step 3 Return to your originating procedure (NTP).
DLP-G173 Enable Dialog Box Do-Not-Display Option
Note If any user who has rights to perform an operation (for example, creating a circuit) selects the “Do not
show this message again” check box in a dialog box, the dialog box is not displayed for any other users
who perform that operation on the network from the same computer unless the command is overridden
using the following task. (The preference is stored on the computer, not in the node database.)
Step 1 From the Edit menu, choose Preferences.
Step 2 In the Preferences dialog box, click the General tab.
The Preferences Management area field lists all dialog boxes where “Do not show this message again”
is enabled.
Step 3 Choose one of the following options, or uncheck the individual dialog boxes that you want to appear:
• Don’t Show Any—Hides all do-not-display check boxes.
• Show All—Overrides do-not-display check box selections and displays all dialog boxes.
Step 4 Click OK.
Step 5 Return to your originating procedure (NTP).
Preview domain
contents
Right-click the domain icon and choose Show Domain Overview. The domain
icon shows a small preview of the nodes in the domain. To turn off the domain
overview, right-click the overview and select Show Domain Overview.
Remove domain Right-click the domain icon and choose Remove Domain. Any nodes in the
domain are returned to the network map.
Purpose This task ensures that a user-selected do-not-display dialog box preference
is enabled for subsequent sessions or to disable the do-not-display option.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Table 10-2 Managing Domains (continued)
Domain Action Steps
To Next Page
Loading...
