Cisco ONS 15454 DWDM - DLP- G186 Delete an OSC Termination

10-41
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 10 Manage the Node
DLP-G186 Delete an OSC Termination
Step 2 Click the GCC that you want to delete.
Step 3 Click Delete.
Step 4 In the Delete GCC Terminations dialog box, check the Set port OOS check box if you want to place
ports out of service.
Step 5 Click Yes . GCC-EOC alarms appear until all network GCC terminations are deleted and the ports are
out of service.
Step 6 Return to your originating procedure (NTP).
DLP-G186 Delete an OSC Termination
Caution Deleting a OSC termination might cause node isolation and loss of visibility to nodes that do not have
other OSCs or network connections to the CTC computer.
Step 1 Click the Provisioning > Comm Channel > OSC tab.
Step 2 If a Ring ID is created, complete the following steps. Otherwise, continue with Step 3.
a. Select the DWDM Ring ID that you want to delete and click Delete.
b. In the Delete DWDM Ring ID confirmation box, click Ye s . Confirm that the changes appear.
Step 3 Click the OSC termination that you want to delete and click Delete.
Step 4 In the Delete OSC Termination confirmation box, click Yes . Confirm that the changes appear.
Until all network OSC terminations are deleted, loss of signal (LOS) or power failure alarms on the
OPT-BST amplifier, OSCM card, and OSC-CSM card might appear.
Step 5 Return to your originating procedure (NTP).
Purpose This task deletes an OSC termination on the ONS 15454.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher