Cisco ONS 15454 DWDM - DLP- G230 Change Line Settings for TXP_MR_2.5 G and TXPP_MR_2.5 G Cards; Table 5-29 TXP_MR_2.5 G and TXPP_MR_2.5 G Transponder Card Settings

5-50
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 5 Provision Transponder and Muxponder Cards
DLP-G230 Change Line Settings for TXP_MR_2.5G and TXPP_MR_2.5G Cards
Step 4 Click Apply.
Step 5 Return to your originating procedure (NTP).
DLP-G230 Change Line Settings for TXP_MR_2.5G and TXPP_MR_2.5G Cards
Step 1 In node view, double-click the TXP_MR_2.5G or TXPP_MR_2.5G card where you want to change the
line settings.
Step 2 Click the Provisioning > Line tabs and any additional PPM tabs depending on the client interface. Tabs
and parameter selections vary according to PPM provisioning.
Step 3 Modify any of the settings described in Table 5-30.
Regeneration
Peer Slot
Sets the slot containing another
TXP_MR_2.5G or TXPP_MR_2.5G card
to create a regeneration peer group. A
regeneration peer group facilitates
management of two TXP_MR_2.5G or
TXPP_MR_2.5G cards that are needed to
perform a complete signal regeneration.
The regeneration peer group
synchronizes provisioning of the two
cards. Payload type and ITU-T G.709
OTN changes made on one
TXP_MR_2.5G or TXPP_MR_2.5G card
are reflected on the peer TXP_MR_2.5G
or TXPP_MR_2.5G card.
Note Y-cable protection groups cannot
be created on TXP_MR_2.5G or
TXPP_MR_2.5G cards that are in
a regeneration peer group.
• None
• 1
• 2
• 3
• 4
• 5
• 6
• 12
• 13
• 14
• 15
• 16
• 17
Regeneration
Group Name
Sets the regeneration peer group name. User defined.
Purpose This task changes the line settings for TXP_MR_2.5G and
TXPP_MR_2.5G transponder cards.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Table 5-29 TXP_MR_2.5G and TXPP_MR_2.5G Transponder Card Settings (continued)
Parameter Description Options