Cisco ONS 15454 DWDM - Figure

7-13
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 7 Create Channels and Circuits
NTP-G60 Create Overhead Circuits
Note The CTC Alerts dialog box will not automatically open to show a deletion error unless you
checked All alerts or Error alerts only in the CTC Alerts dialog box. For more information, see
the “DLP-G53 Configure the CTC Alerts Dialog Box for Automatic Popup” task on page 2-32.
If the CTC Alerts dialog box is not set to open automatically with a notification, the red triangle
inside the CTC Alerts toolbar icon indicates that a notification exists.
Step 8 Complete one of the following:
• If you checked Notify when completed, the CTC Alerts dialog box appears. If you want to save the
information, continue with Step 9. If you do not want to save the information, continue with Step 10.
• If you did not check Notify when completed, the Circuits window appears. Continue with Step 11.
Step 9 If you want to save the information in the CTC Alerts dialog box, complete the following steps. If you
do not want to save it, continue with Step 10.
a. Click Save.
b. Click Browse and navigate to the directory where you want to save the file.
c. Type the file name using a .txt file extension, and click OK.
Step 10 Click Close to close the CTC Alerts dialog box.
Step 11 Complete the “NTP-G103 Back Up the Database” procedure on page 13-2 if you require a backup of
your changes.
Step 12 Return to your originating procedure (NTP).
NTP-G60 Create Overhead Circuits
Step 1 Complete the “DLP-G46 Log into CTC” task on page 2-25 at the node where you will create the
overhead circuit. If you are already logged in, continue with Step 2.
Step 2 Choose View > Go to Network View.
Step 3 As needed, complete the “DLP-G76 Provision GCC Terminations” task on page 7-14.
Step 4 As needed, complete the “DLP-G97 Provision a Proxy Tunnel” task on page 7-15.
Step 5 As needed, complete the “DLP-G98 Provision a Firewall Tunnel” task on page 7-16.
Purpose This procedure creates overhead circuits on an ONS 15454 network.
Overhead circuits include generic communications channels (GCCs),
IP-encapsulated tunnels, the AIC-I card orderwire, and the AIC-I card
UDC.
Tools/Equipment None
Prerequisite Procedures None
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher