2-31
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 2 Connect the PC and Log into the GUI
DLP-G51 Delete a Node from a Specified Login Node Group
DLP-G51 Delete a Node from a Specified Login Node Group
Step 1 From the CTC Edit menu, choose Preferences.
Step 2 In the Preferences dialog box, click the Login Node Groups tab.
Step 3 Click the login node group tab containing the node you want to remove.
Step 4 Click the node you want to remove, then click Remove.
Step 5 Click OK.
Step 6 Return to your originating procedure (NTP).
DLP-G52 Change the JRE Version
Note This task is not used in Release 6.0 because only one JRE version is supported. This task is used in CTC
releases that support multiple JRE versions.
Step 1 From the Edit menu, choose Preferences.
Step 2 Click the JRE tab. The JRE tab shows the current JRE version and the recommended version.
Step 3 Click the Browse button and navigate to the JRE directory on your computer.
Step 4 Choose the JRE version.
Step 5 Click OK.
Purpose This task removes a node from a specified login node group. To remove a
node from the current login node group, see the “DLP-G50 Delete a Node
from the Current Session or Login Group” task on page 2-30.
Too ls None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task changes the JRE version, which is useful if you would like to
upgrade to a later JRE version from an earlier one without using the
software or documentation CD. This does not affect the browser default
version. After selecting the desired JRE version, you must exit CTC. The
next time you log into a node, the new JRE version will be used.
Too ls None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
