10-39
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 10 Manage the Node
NTP-G85 Modify or Delete OSC Terminations, GCC Terminations, and Provisionable Patchcords
NTP-G85 Modify or Delete OSC Terminations, GCC Terminations,
and Provisionable Patchcords
Caution Deleting an OSC termination can cause you to lose visibility of nodes that do not have other OSCs or
network connections to the CTC computer.
Step 1 Complete the “DLP-G46 Log into CTC” task on page 2-25. If you are already logged in, continue with
Step 2.
Step 2 In node view, complete the following tasks as needed:
• To modify a GCC termination, complete the “DLP-G184 Change a GCC Termination” task on
page 10-40.
• To delete a GCC termination, complete the “DLP-G185 Delete a GCC Termination” task on
page 10-40.
• To delete an OSC termination, complete the “DLP-G186 Delete an OSC Termination” task on
page 10-41.
• To delete a provisionable patchcord, complete the “DLP-G187 Delete a Provisionable Patchcord”
task on page 10-42.
Stop. You have completed this procedure.
Purpose This procedure modifies GCC terminations, and deletes provisionable
patchcords, OSC terminations, and GCC terminations.
Tools/Equipment None
Prerequisite Procedures DLP-G76 Provision GCC Terminations, page 7-14 or
NTP-G38 Provision OSC Terminations, page 3-84
DLP-G99 Create a Provisionable Patchcord, page 6-11
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
